Table of Contents
Advertisement
Chapter 12: BlueSecure Access Points
Configuring Global Miscellaneous Non-Radio Settings
The Wireless Global System Settings page is used to specify the country in which the
BSAPs are located and to enable remote SSH diagnostics (this option only applies to
BSAP-15x0 platforms).
You can optionally override these global settings for individual BSAPs on the Wireless AP
tab by clicking the pencil icon for the BSAP.
To configure miscellaneous non-radio settings for all BSAPs:
Displaying the
1.
Click the Wireless tab in the BSC administrator console, click the Global tab, and
Edit AP System
then click the System link at the top of the page.
Settings - Global
The Edit AP System Settings - Global page appears as shown in Figure 12-6.
page
Firmware
Note that the page indicates the global firmware status for each BSAP model. For
instructions on how to change the default firmware for a BSAP model, see "Uploading
BSAP Firmware Files" on page 12-6.
Region Options
Select the Country/Region from the drop-down in which the radio is to be operated.
(Default: United States). The country selection enables the BSC to automatically adjust
channels and power on the APs to conform to what is permitted in the regulatory domain.
Important: Wireless Regulatory Compliance
Based on United States FCC and European DFS and ETSI regulations, Bluesocket requires
customers to validate the country in which Bluesocket Access Points are being operated.
This prevents the Bluesocket hardware from accidentally being used in an improper
configuration.
12-8
Figure 12-6: Edit AP System Settings - Global Page
Advertisement
Table of Contents
