Configuring Vtm Administrator Email Paging; Configuring The Smtp And Snmp Settings - NEC Express5800/320Ma Administrator's Manual

To set up a VTM administrator account
1. In ftSMC, expand ftServer (Local), ftServer Configuration, right-click
ActiveService Network, and select Properties.
2. On the dialog box, click the SMM tab.
3. Enter values into the following fields:
– SMM Admin ID. Your VTM administrator login name.
– SMM Admin Password. Your VTM administrator password.
– SMM Admin Dialback Number. The phone number you use to dial in to the
VTM adapter. After you dial in and are authenticated as the Admin, the VTM
hangs up the connection and dials the dialback number to reestablish the
connection.
4. Click OK.

Configuring VTM Administrator Email Paging

You can configure your VTM to email you VTM alerts. Verify that your
address is correct if you are enabling email paging.
To configure VTM administrator email paging
1. In ftSMC, expand ftServer (Local), ftServer Configuration, right-click
ActiveService Network node, and select Properties.
2. In the properties page, click the SMM tab.
3. In the SMM Admin Enable Email box, set the value to False to disable or True to
enable the sending of VTM email alerts.
4. In the SMM Admin Email Address box, enter your email address.
5. Click OK.

Configuring the SMTP and SNMP Settings

Configure the Simple Mail Transfer Protocol (SMTP) and Simple Network Management
Protocol (SNMP) settings to indicate the IP addresses to use for VTM email notification
and for communication between the VTM and the SMTP/SNMP servers. Contact your
network administrator for the correct addresses.
To configure SMTP and SNMP settings
1. In ftSMC, expand ftServer (Local), ftServer Configuration, right-click VTM
Network Config node, and select Properties.
2. On the VTM Network Config Properties page, click the SMTP/SNMP tab.
3. Enter values for the following properties:
Operating and Monitoring Your System
Using the VTM
SMTP server IP
2-7