Relay Control - Gemini GEM-P9600 Installation Instructions Manual

WI742C 08/00
! relative signal strength of the last transmission, on a scale of 1-10 (10 being the strongest). ("SS—" indicates
transmission not yet received.) Note: A signal strength of 3 or less is an indication that reception may be unreliable.
In such cases, the use of an additional receiver located closer to the transmitter is recommended. If two receivers
are connected to the GEM-P9600, only the higher signal strength of the two will be displayed.

RELAY CONTROL

Press YES ( button) to check the status (all on or all off) of up to 8 groups programmed with any combination of up
E
to 96 available external relays. The group number will display with a related description. Scroll through the groups using
the NEXT ( ) and PRIOR (
E
L
NAPCO Security Systems
) buttons; change the status of the displayed group by pressing the
F
X
GEM-P9600 Installation Instructions
!
Page 29
J
button.