Table of Contents
Advertisement
15.0 - R
EMOTE CONTROL BATTERY REPLACEMENT
When the remote control batteries are too weak, replace them as follows:
!
Separate the shell halves taking care not to damage the internal circuit.
!
Remove the discharged batteries.
!
Insert the new ones taking care not to invert the polarity.
!
Close the plastic shells and make sure the remote works properly.
BATTERIES
!
WARNING
U
se only CR1616 batteries.
There is a serious risk of explosion if batteries are replaced by an
incorrect type.
Different type batteries can also seriously damage the remote control.
Discard used batteries properly in special dedicated containers
16.0 - CONTROL UNIT MAINTENANCE
Care should be taken to protect the electronic device:
!
D
o not clean the
unit with water but use a damp cloth to wipe.
!
Do not use voltages other than the one specified by the manufacturer.
!
Do not remove warranty labels.
17.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE) as specified in art. 2.1 of
L.D. no. 151 of 25/07/2005.
Page 12
Page 12
.
18.0
18.0 - COMMANDS
REQUEST
setup#password#basic#main phone
Initial configuration and/or
number#new password#emergency phone
data modification
Initial configuration and/or
setup#password#basic#main phone
data modification with STOP
number#new password#emergency phone
& GO activation
Initial configuration and/or
setup#password#basic#main phone
data modification with STOP
number#new password#emergency phone
& GO deactivation
Initial configuration with
tilt
setup#password#nav#main phone
sensor exclusion
and/or
number#new password#emergency phone
data modification
Vehicle localization
Tracking
(
vehicle displacement
)
Speed alert
Engine immobilizer activation
Engine immobilizer disabling
Blinker and siren (optional)
activation
System arming
System disarming
System status
Passive arming & Sleep mode
Periodic position control
Auxiliary input setup
(AUX)
Servicing mode ON
Servicing mode OFF
(Ref.01) Speed limit indicative value (expressed in km/h, always 3 digits .
(Ref.02) 'x'
: 0 = disable, 1 = enable passive arming .
(Ref.03)
Indicative value for the time interval after which vehicle position must
be checked (expressed in minutes, always 3 digits).
(Ref.04)
See installer manual.
COMMAND
number#
number#f#
number#s#
number
#
loc#password#
trk#password#
speed#password#060
(ref.01)
stop#password#
go#password#
blinker#password#
on#password#
off#password#
status#password#
pas#password#x,0#
(ref. 02)
pos password
#
#180
(ref.03)
aux#password#n
(ref.04)
seron#password#
seroff#password#
)
Page 13
Page 13
Advertisement
Table of Contents
