Table of Contents
Advertisement
Installation
Connections
Installation of the X-DVIPRO and X-DVIPRO-MS2 modules is straightforward and
requires minimal configuration in most cases.
•
Connections at the local module
•
Connections at the remote module
Note: After all connections are made, power up the monitor and the REMOTE
module first (followed by the LOCAL module, if using the X-DVIPRO-MS2
variant) and then switch on the computer.
Mounting the modules – desk or rack
The X-DVIPRO and X-DVIPRO-MS2 modules can be situated on a desk or
alternatively, for larger installations, mounted within an optional rack mount
chassis.
Desk mount
Apply the supplied self-adhesive rubber
feet to the underside of the module.
Rack mount
1 Place the rack securing plate (available as a separate kit) onto the front of the
module and secure it with the two countersunk screws.
2 Orient the X-DVIPRO (or X-DVIPRO-MS2) module on its side so that its
labelled face is the correct way up.
3 Slide the module into the required rack position. The rectangular cut-out in
the front upper lip of the rack allows the two screws on the module's upper
edge to slide through.
4 The rack mount chassis has a series of holes in its floor that are spaced to
accommodate the two screws on the module's lower edge. Ensure that
the screws correctly locate into the two holes of the chosen slot. The rack
securing plate on the module should now be flush with the front of the
rack mount chassis.
5 Use the third (pan-head) screw, in the top hole of the rack
securing plate to fasten the module to the rack.
5
Advertisement
Table of Contents
