Related Manuals for Miele K 3211 S
Summary of Contents for Miele K 3211 S
- Page 1 Operating and installation instructions Refrigerators K 3211 S K 3214 S It is to read these operating instructions before installing or using the machine, to avoid the risk of accident or damage to the machine. M.-Nr. 05 590 540...
- Page 2 Contents ........4 .
- Page 3 ..........20 Electrical connection U.K.
- Page 4 Description of the appliance On/Off and temperature selector dial Butter and cheese compartment Interior lighting Egg trays Shelves Adjustable door shelf Bottle rack (depending on model) Divider (depending on model) Condensate channel and drain hole Fruit and vegetable containers...
- Page 5 Caring for the environment Old appliances contain materials which can be reclaimed or recycled. Please The transport and protective packing contact your dealer, your waste collec- has been selected from materials tion centre or scrap merchant about which are environmentally friendly for potential recycling schemes.
- Page 6 Warning and safety instructions In addition to the noise of the com- This appliance complies with all rele- pressor you might be able to hear the vant legal safety requirements. Im- coolant flowing around the system. This proper use of the appliance can, is unavoidable, but does not have any however, present a risk of both per- adverse effect on the performance of...
- Page 7 The electrical safety of this ap- The appliance is only completely pliance can only be guaranteed isolated from the electricity supply when continuity is complete between when: the appliance and an effective earthing – the plug has been withdrawn. system which complies with local and Do not pull on the cable, only on the national safety regulations.
- Page 8 Do not use sharp edged electrical components and cause a objects to short circuit. – remove frost and ice, In countries where there are areas – separate frozen foods and remove which may be subject to infesta- ice trays. tion by cockroaches or other vermin, They will damage the evaporator and pay particular attention to keeping the the appliance will not be able to be...
- Page 9 Operation Clean the inside of the appliance and the accessories with luke warm If the appliance is not going to be used water and a little washing up liquid for a longer period of time, e.g. whilst and then dry using a soft cloth. on holiday switch the appliance off at the mains, withdraw the plug (pull on the plug...
- Page 10 The correct temperature It is very important to set the correct temperature for storing food in the ap- The temperature is set with the tem- pliance. Micro organisms will cause perature dial. food which is not stored at the correct temperature to deteriorate rapidly.
- Page 11 Storing food Natural air circulation gives rise to differ- ent temperature zones inside the ap- When placing food in the appliance pliance. Cold, heavy air sinks to the load the top shelves first and work lowest section of the appliance. your way down to the bottom starting with baked goods, pre-cooked foods Make use of the different zones...
- Page 12 Adjusting the interior fittings The shelves can be adjusted according Push the door shelf upwards then to the height of the food. remove it by pulling it forwards. Pull the shelves forward as far as Replace the door shelf at the re- they will go then lift them upwards to quired position.
- Page 13 Chilling and storing food Use the different cooling zones for Not all food is suitable for refrigeration. storing food correctly. See the sec- These include: tion on loading examples. – Fruit and vegetables such as bananas, avocado pears, papaya, – Food must not touch the back wall of passion fruit, aubergines the appliance.
- Page 14 Defrosting Condensate and frost can build up on the back wall of the appliance whilst it is in use. These are automatically removed and defrosted by the ap- pliance. The condensate is drained away via a channel and drain hole into an evapora- tion system at the back of the ap- pliance.
- Page 15 Cleaning and care Never use cleaning agents contain- ing abrasive substances such as sand, soda, acids or chemical sol- Use lukewarm water with a little wash- vents. ing up liquid. Accessories and shelves should be hand washed only. The but- "Non-abrasive"...
- Page 16 The metal grille at the back of the ap- pliance (heat exchanger) should be dusted at least once a year. A build up of dust will increase the energy con- sumption of the appliance. When cleaning the grille, make sure that the pipework and other compo- nents do not get broken or dam- aged in any way.
- Page 17 Check that the fuse is not defective and that the mains fuse has not The following can be corrected without blown. If it has contact the Miele Ser- contacting the Miele Service Depart- vice Department. ment: Turn the temperature dial to a setting closer to “0".
- Page 18 If you still cannot remedy the fault Disconnect the appliance from the having followed these suggestions, mains. Switch off at the wall and with- then contact the Miele Service De- draw the plug from the socket (pull partment. by the plug not the cable), or discon-...
- Page 19 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting the Service Depart- ment, please quote the model and ser-...
- Page 20 Electrical connection The wires in the mains lead are col- The appliance is supplied with a mains oured in accordance with the following cable and moulded plug ready for con- code: nection to an a.c. single phase 220 – 240 V 50 Hz supply. The fuse rating is Green/yellow = earth 13 amps.
- Page 21 (as applicable to the design of the plug fitted). The correct fuse rating of the replace- ment fuses that are ASTA approved to BS 1362 should be fitted. Replacement fuse covers may be purchased from your local electrical supplier, or Miele Service agent.
- Page 22 Installation Do not place any appliance which gives off heat, such as a toaster or Air at the rear of the appliance gets microwave oven on top of this ap- warm. To ensure sufficient ventilation pliance, as this would increase the the ventilation gaps must not be appliance’s energy consumption.
- Page 23 Changing the door hinging The appliance is supplied right hand hinged. If you want it left hand hinged follow the instructions below. Open the appliance door. Unscrew the upper hinge pin using the spanner supplied and refit on the opposite side. Use a screwdriver to lever the plinth Remove spacer with a screwdriver...
- Page 24 Open the appliance door. Unclip covers at the front and slide off to the side. Unscrew handle , and remove stoppers . Refit on the opposite side of the door. Slide covers into position, making sure they click into position correctly. Turn door support around, pull the hinge pin...
- Page 25 Building in The air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis. When built into a kitchen run (max. depth 580 mm) the appliance can be installed directly next to a kitchen furni- ture housing unit.
- Page 28 Alteration rights reserved / 44 / 001 GB - 1401 This paper consists of cellulose which has been bleached without the use of chlorine.