Advertisement
Is the temperature selector at a set-
ting other than "0"? If it is then the
bulb may be defective and need re-
placing.
Disconnect the appliance from the
mains. Switch off at the wall and with-
draw the plug from the socket (pull
by the plug not the cable), or discon-
nect the mains fuse or remove the
screw-out fuse in countries where
this is applicable.
Press the sides of the lamp cover in-
wards, disengage the cover and un-
clip it at the rear.
Unscrew the bulb and replace it with
a new one.
Bulb specification:
220 – 240 V, max. 25 W, E 14 fitting
When fitting in the new bulb make
sure that it is correctly fitted.
Clip the lamp cover back in at the
rear and then press it into position
from the sides.
18
The drain hole has become blocked.
Clean the condensate channel and
drain hole.
If you still cannot remedy the fault
having followed these suggestions,
then contact the Miele Service De-
partment.
To prevent unecessary loss of tem-
perature it is advisable not to open
the door while waiting for the ap-
pliance to be serviced.
Advertisement
