Advertisement
Installation
Do not place any appliance which
gives off heat, such as a toaster or
microwave oven on top of this ap-
pliance, as this would increase the
appliance's energy consumption.
The appliance should be installed in a
dry, well ventilated room.
The room temperature should not go
above or below the climate range for
which the appliance is designed. The
higher the ambient temperature of the
room the more energy the appliance re-
quires to operate. It should not be in-
stalled where it is exposed to direct
sunlight or directly adjacent to a heat-
producing appliance such as an oven
or a radiator.
The appliance is designed for a particu-
lar climate range (ambient room tem-
perature), and should not be used out-
side this range. The climate range of
this appliance is stated on the data
plate inside the appliance.
SN
N
ST
T
Operating in a room which is too cold
will cause the cooling system to switch
off for too long causing the internal tem-
perature in the appliance to rise with
the risk of food deteriorating and going
off.
22
+10 °C to +32 °C
+16 °C to +32 °C
+18 °C to +38 °C
+18 °C to +43 °C
Air at the rear of the appliance gets
warm. To ensure sufficient ventilation
the ventilation gaps must not be
covered over.
The air inlet and outlet must not be
covered or blocked in any way. They
should be dusted on a regular basis.
When you open the door for the first
time, the handle will make a clicking
sound. This is quite normal and indi-
cates that it has adjusted itself from its
transit position to its operational posi-
tion. The handle will now protrude
slightly more in front of the appliance
than it did during transportation.
Remove any cable clips from the
rear of the appliance.
Check that all parts at the rear of the
appliance are unhindered.
Carefully push the appliance into po-
sition.
To align the appliance adjust the feet
using the spanner supplied.
Advertisement
