Electrical Connection And Technical Data - Miele KM 89-2 Operating Instructions Manual

Electrical connection and technical data

Electrical connection
General notes
Electrical connection of the appliance
should be undertaken by a qualified
electrician in strict accordance with
national and local safety regulations.
This appliance conforms to EN 55014.
For extra safety it is advisable to install
a residual current device (RCD), with a
trip current of 30 mA.
Electrical connection U.K., AUS
The appliance is supplied for connec-
tion to an a.c. single phase 240 V
(230 V), 50 Hz supply.
Connection should be made by a fused
plug (U.K. only) and switched socket.
The On-Off switch should be easily ac-
cessible after the appliance has been
built-in.
The data plate gives the necessary
data for connection. See page 13.
Electrical connection and technical data
(IRL, NZ, ZA)
Important:
The wires in the mains lead are col-
oured in accordance with the following
code:
Green/yellow = earth
Blue = neutral
Brown = live
As the colours of the wires in the mains
lead of this appliance may not corre-
spond with the coloured makings ident-
ifying the terminals in your plug, pro-
ceed as follows:
The wire which is coloured green and
yellow must be connected to the termi-
nal in the plug which is marked with the
letter E or by the earth symbol z or
coloured green or green and yellow.
The wire which is coloured blue must
be connected to the terminal which is
marked with the letter N or coloured
black.
For U.K.: The wire which is coloured
brown must be connected to the termi-
nal which is marked with the letter L or
coloured red.
For Australia: The wire which is col-
oured brown must be connected to the
terminal which is marked with the letter
A or coloured red.
WARNING
THIS APPLIANCE MUST BE
EARTHED
15