Data Plate - Miele KM 402 Operating Instructions Manual

This appliance should be installed with
plenty of space on either side. See In-
stallation Instruction Booklet before
making electrical connection.
All electrical work should be carried
out by a suitably qualified and com-
petent person in strict accordance
with national and local safety regula-
tions.
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer can-
not be held responsible for un-
authorised work.
Ensure power is not supplied to the
appliance while installation or repair
work is being carried out.
The appliance must only be oper-
ated when built-in. This is to ensure
that all electrical parts are shielded.
Live parts must not be exposed.
Do not connect the appliance to the
mains electricity supply by an exten-
sion lead. These do not guarantee
the required safety of the appliance.
The voltage, rated load and fusing are
given on the data plate. Ensure that
these match the household mains sup-
ply.
24
Connection of this appliance should be
made via a suitable isolator or a double
pole fused spur connection unit or
fused plug and switched socket which
complies with national and local safety
regulations and the on/off switch should
be easily accessible after the appliance
has been built in.
If the socket is not accessible after in-
stallation (depending on country) an
additional means of disconnection must
be provided for all poles.
For extra safety it is advisable to install
a residual current device with a trip cur-
rent of 30 mA (in accordance with DIN
VDE 0664, VDE 0100 Section 739).
When switched off there must be an
all-pole contact gap of 3 mm in the iso-
lator switch (including switch, fuses and
relays according to EN 60 335).
This appliance is supplied for connec-
tion to a single phase 230-240 V 50 Hz
supply with a 3-core cable.
The wires in the mains lead are col-
oured in accordance with the following
code:
Green/yellow = earth
Blue = neutral
Brown = live