Miele KM 89-2 Operating Instructions Manual page 19

Instructions for building-in
Stick the seal provided
edge of the deep fat fryer.
loosen
b
Appliance
c
Tensioning screw
d
Clamp
e
Worktop
f
Seal
Turn the tensioning screws
clamps on the appliance
anti-clockwise direction until a resist-
ance is met and turn the clamps to
the left.
Place the appliance into position,
turn the clamps and tighten the ten-
sioning screws until the clamps
press into the worktop
Connect the appliance to the elec-
tricity supply.
A gap the width of an appliance has
to be assured between a gas hob
and a deep fat fryer to avoid any
source of ignition.
f
under the
tighten
c
in the
b
in an
e
.
Instructions for building-in
When building-in several Combiset
units, a spacer bar must be fitted
between the units. It is supplied with its
own installation instructions.
19