Select Controller; Physical Configuration Window - ICP RS Series User Manual

K.3 Select Controller
This window is used to select an
ICP Controller for all further ac-
tions within the ICP RAID Naviga-
tor.
In a first step you should select
the desired protocol (Windows
NT/95/98, Sockets, IBM NetBIOS)
for the communication between
the ICP RAID Navigator and the
system which is equipped with the
ICP Controller by double clicking
on the protocol icon on the very
left side of the window. If you want
so select an ICP Controller via
TCP/IP (sockets), type in the corre-
sponding TCP/IP address or the
server system's name. You are
then asked to enter a user name
and a password. This information is transmitted with encryption.
K.4 Physical Configuration Window
This window shows the physical configuration of the SCSI or Fibre Channel
busses of the selected ICP Controller and the devices connected with these
busses. The complete configuration is shown as a tree starting from the left
with the ICP Controller.
To get detailed information on the single devices, double click on the icons.
The windows that open, depend on the type of the selected device.
To change the physical configuration of the devices, click the right mouse button on the
desired device or select the corresponding item from the Configuration menu.
Possible choices are (Click on the popup menu items to get information on them):
159
After the protocol was selected, select the system which
contains the ICP Controller and afterwards the ICP Control-
ler itself. The selection and de-
selection is done by double
clicking on the ICP Controller.
The selected protocol, system
and ICP Controller are shown in
a dashed yellow frame.
No more action can be done in
this menu.