Table of Contents
Advertisement
Hardware Installation
Figure 2-1. ICP RAID Controller Component Layout
2.2.2
Installing the ICP RAID Controller
1. Power-off the computer system.
2. Disconnect power cord(s) and remove the system cover.
3. Install the ICP RAID controller into an available RAIDIOS-enabled PCI slot. See
Figure
Note:
The computer system (with RAIDIOS-enabled PCI slot) illustrated in
not be representative of your system. Consult your system docs for the exact location of
the RAIDIOS-enabled PCI slot.
4. Connect one end of the SCSI cable to the on-board SCSI connector. Connect the other
end of the SCSI cable to the SCSI drives or drive enclosure.
Ensure that the end of the SCSI bus is properly terminated. See
Note:
guide for termination details.
5. Replace the system cover and reconnect power cord(s).
Warning: Attention the controller CPU can get HOT! Controller requires constant airflow for
cooling (min 1m/sec).
12
167mm (6.57 inches)
DS2A1
J1B1
Flash Memory
2-2.
I/O Processor
64Bit 3.3 Volt PCI Interface
(Requires a RAIDIOS-enabled PCI slot)
Hardware Installation and User's Guide
SDRAM
may
Figure 2-2
Section 2.4
in this
Advertisement
Table of Contents
