ICP RS Series User Manual page 87

Change all command lines in STARTUP.NCF and in AUTOEXEC.NCF from DSK to HAM.
If CTRLTRAN.DSK is loaded directly, this command line must also be changed
(CTRLTRAN.HAM). If the DSK driver is replaced by the HAM driver, the slot number pa-
rameter has to be changed as well.
ASPITRAN.DSK is not required any more and can be deleted. NWASPI.CMD is used in-
stead (part of NWPA_411.EXE). This ASPI driver has to be loaded if you want to use
ASPI devices.
New Installation of NetWare 4.x with ICP HAM driver support
For a new installation with the ICP HAM driver the following steps are required:
Create a temporary directory on the boot drive (e.g., C:\NWPA).
Copy the file NWPA_411.EXE to the temporary directory C:\NWPA and start it there.
The file is self-extracting and can be deleted after use (see note on previous side)
Start the NetWare server installation.
If the message "Install found the following hardware but was unable to find a matching
driver" appears, switch to the file server console with (<ALT>-<Esc>).
Type "SEARCH ADD 1 C:\NWPA" at the file server console.
Type "LOAD C:\NWPA\NWPALOAD" at the file server console.
Return to the installation screen (<ALT>-<Esc>).
Press <RETURN> to get a list of all available drivers.
Press <INSERT> to select additional drivers.
Insert a prepared floppy disk with the ICP HAM driver (and DDI file) into the floppy drive
and press <RETURN>. After reading the floppy disk information a new list appears.
Select the ICP HAM driver now.
The installation process asks now for the slot number of the ICP Controller. To deter-
mine this number, the following steps should be carried out:
Switch to the file server console with <Alt>-<ESC>.
Type "LOAD GDTRP1xy.HAM".
The driver now determines the slot number(s) and displays all slot numbers of all
ICP Controllers. They should be written down.
Press <ESC> to stop the driver loading procedure.
Return to the installation screen (<ALT>-<Esc>).
Now insert the slot number of the ICP Controller. If there are additional ICP Controllers
in the system, load a driver for each of them with a unique slot number. Do not use the
same slot number for more than one ICP Controller.
87