ICP RS Series User Manual page 103

Further driver parameters:
irq1,irq2, etc.
disable:Y
disable:N
reserve_mode:0
reserve_mode:1
reserve_mode:2
reserve_list:h,b,t,l,h,b,t,l,
reverse_scan:Y
reverse_scan:N
max_ids:x
rescan:Y
rescan:N
[*1] The driver parameters reserve_mode and rescan:N require ICP Controllers with firm-
ware version FW 1.23.00/2.23.00 or higher.
The current default settings of the driver are:
"gdth=disable:N,reserve_mode:1,reverse_scan:N,max_ids:127,rescan:N"
If gdth is loaded as a module, these parameters can also be added with a special syntax.
IRQ parameters are entered as 'IRQ=' (e.g. IRQ=10). Several parameters are not separated
with a comma (',') but a space (' '). All ':' are substituted with '=', all 'Y' with '1' and all 'N'
with '0'.
Default: "modprobe gdth disable=0 reserve_mode=1 reverse_scan=0
max_ids=127 rescan=0"
103
Only for ICP EISA Controllers with disabled BIOS (irq1, irq2,
etc. correspond with the IRQs of the ICP Controllers)
deactivates the ICP driver
activates the ICP driver
reserves no SCSI devices [*1]
reserves all not-initialized removable hard disk [*1]
reserves all not-initialized SCSI devices [*1]
reserves SCSI devices at the corresponding coordinates with
h=Hostadapter, b=SCSI Bus, t=Target ID, l=LUN
reversed scanning order of the PCI controllers
normal scanning order of PCI Controllers according to the
system BIOS
x = number of target IDs per SCSI channel
(accelerates the boot process)
rescan all SCSI channels / IDs
scan only those SCSI devices found during
system power up [*1]