Table of Contents
Advertisement
Updating the Flash Using the AFU Command
Line
Create the firmware floppy disks (see
1
Power off your computer, insert the first AFU floppy disk, then
2
power on your computer.
If your computer isn't set up to boot from the bootable floppy disk,
enter the system setup utility to change the setting.
At the DOS command, if you have multiple controllers and you don't
3
know the number of the controller you want to update, type
then press Enter. Otherwise, skip to the next step.
At the DOS command, type AFU followed by a command (see
4
119) and any switches you want.
Update the flash using the instructions suitable for your
5
requirements:
To update a single RAID controller:
AFU UPDATE /C
Where
<cont_number>
whose firmware you are updating. For example, to upgrade
Controller 0, type
To update multiple RAID controllers:
AFU UPDATE /C
Where
<controller_number_a>
numbers of the Adaptec RAID controllers whose firmware you
are updating. For example, to upgrade controllers 0, 2, and 3,
type
AFU UPDATE /C 0, 2, 3
To update all RAID controllers simultaneously:
AFU UPDATE /C all
Note: The UFI file identifies the RAID controllers, so you don't
have to worry about flashing the wrong controller.
Appendix E: Using the Adaptec Flash Utility
<cont_number>
is the number of the RAID controller
AFU UPDATE /C 0
<cont_number_a>,<cont_number_b>
page
117).
and
<controller_number_b>
123
,
AFU LIST
page
are the
Hide quick links:
Advertisement
Table of Contents
