Configuring Nat - Prestige; Figure 75 Configuration > Nat - Prestige; Table 46 Configuration > Nat - Prestige - ZyXEL Communications Vantage CNM User Manual

Table 45 Configuration > NAT - ZyWALL
LABEL
NAT Trigger Port
Copy
WAN 1, 2
None
SUA Only
Full Feature
Edit
Apply

9.3 Configuring NAT - Prestige

You must create a firewall rule in addition to setting up NAT, to allow traffic from the WAN
to be forwarded through the ZyXEL device.
Select a device and then click Configuration > NAT.
Figure 75 Configuration > NAT - Prestige
The following table describes the fields in this screen.
Table 46 Configuration > NAT - Prestige
LABEL
None
SUA Only
Full Feature
Chapter 9 Configuration > NAT
DESCRIPTION
Click Copy WAN1 to WAN 2 (or Copy WAN2 to WAN 1) to duplicate this WAN
port's NAT trigger port rules on the other WAN port.
Note: Using the copy button overwrites the other WAN port's existing
rules.
The copy button is best suited for initial NAT configuration where you have
configured NAT trigger port rules for one port and want to use similar rules for the
other WAN port. You can use the other NAT screens to edit the NAT rules after you
copy them from one WAN port to the other.
Select None to disable NAT on the ZyXEL device.
Select SUA Only to apply many-to-one mapping only (sufficient if the device has
only one public IP address).
Select Full Feature to avail of multiple mapping types.
Click Edit to advance to the selected feature.
Click Apply to begin configuring this screen afresh.
DESCRIPTION
Select None to disable NAT on the ZyXEL device.
Select SUA Only to apply many-to-one mapping only (sufficient if the device has
only one public IP address).
Select Full Feature to avail of multiple mapping types.
Vantage CNM User's Guide
148