Wan Isp - Zywall; Ethernet Encapsulation; Figure 60 Configuration > Wan > Isp (Ethernet) - Zywall; Table 32 Configuration > Wan > Isp (Ethernet) - Zywall - ZyXEL Communications Vantage CNM User Manual

Vantage CNM User's Guide
Table 31 Configuration > WAN > General - ZyWALL (continued)
LABEL
Timeout (sec)
Apply
Reset

8.4.1 WAN ISP - ZyWALL

The screen differs by the encapsulation type chosen.
Figure 60 Configuration > WAN > ISP (Ethernet) - ZyWALL

8.4.1.1 Ethernet Encapsulation

The following table describes the labels in the Ethernet encapsulation screen.
Table 32 Configuration > WAN > ISP (Ethernet) - ZyWALL
LABEL
Encapsulation
Service Type
Apply
Reset
117
DESCRIPTION
Type the number of seconds for the ZyXEL device to wait for a ping response from
the IP Address in the Check WAN IP Address field before it times out. The WAN
connection is considered "down" after the ZyXEL device times out the number of
times specified in the Fail Tolerance field. Use a higher value in this field if your
network is busy or congested.
Click Apply to save your changes back to the ZyXEL device.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
You must choose the Ethernet option when the WAN port is used as a regular
Ethernet.
Choose from Standard, Telstra (RoadRunner Telstra authentication method),
RR-Manager (Roadrunner Manager authentication method), RR-Toshiba
(Roadrunner Toshiba authentication method) or Telia Login.
The following fields do not appear with the Standard service type.
Click Apply to save your changes back to the ZyXEL device.
Click Reset to begin configuring this screen afresh.
Chapter 8 Configuration > WAN