Figure 67 Configuration > Wan > Dial Backup > Advanced - Zywall; Table 37 Configuration > Wan > Dial Backup > Advanced - Zywall - ZyXEL Communications Vantage CNM User Manual

Figure 67 Configuration > WAN > Dial Backup > Advanced - ZyWALL
The following table describes the labels in this screen.
Table 37 Configuration > WAN > Dial Backup > Advanced - ZyWALL
LABEL
AT Command
Strings
Dial
Drop
Answer
Drop DTR When
Hang Up
AT Response
Strings
CLID
Called ID
Speed
Call Control
Dial Timeout (sec) Type a number of seconds for the ZyXEL device to try to set up an
Chapter 8 Configuration > WAN
DESCRIPTION
Type the AT Command string to make a call.
Type the AT Command string to drop a call. "~" represents a one
second wait, for example, "~~~+++~~ath" can be used if your
modem has a slow response time.
Type the AT Command string to answer a call.
Select this check box to have the ZyXEL device drop the DTR
(Data Terminal Ready) signal after the "AT Command String:
Drop" is sent out.
Type the keyword that precedes the CLID (Calling Line
Identification) in the AT response string. This lets the ZyXEL
device capture the CLID in the AT response string that comes from
the WAN device. CLID is required for CLID authentication.
Type the keyword preceding the dialed number.
Type the keyword preceding the connection speed.
outgoing call before timing out (stopping).
Vantage CNM User's Guide
EXAMPLE
atdt
~~+++~~ath
ata
NMBR
CONNECT
60
128