Zibro S185 Operating Manual page 16

OPERATING INSTRUCTIONS
FEEL mode operating procedure
The operating mode is selected automatically (HEATING, DRY,
FAN, COOLING), depending on the room temperature at the
time the selection takes place.
With the remote control pointed at the air conditioner.
1. Activation
Press the ON/OFF/RUN button. The RUN indicator on the
indoor unit will light up when the machine receives a signal.
When the unit is not in the FEEL mode.
2. Selecting the FEEL mode
Press the MODE selector button.
Adjust the MODE to the FEEL setting.
The operating mode and temperature are determined by the
indoor temperature.
Indoor temperature
Less than 20 °C
20 – 26 °C
More than 26 °C
3. Temperature adjustment
Press the button or the
When the button is pressed, the value of the preset temperature increases by 1°C.
The indicator will not change after the temperature has been increased by 2°C.
When the button is pressed, the value of the preset temperature is lowered by 1°C.
The indicator will not change after the temperature has been lowered by 2°C.
Note:
It may occur that no air is expelled from the unit while it is in operation.
The unit will not always start operating immediately after the mode has been changed.
TIMER mode
If you program the timer with the TIMER button upon leaving, it will be pleasantly warm when you return
home. You can deactivate the timer at night if you wish.
4
16
Operating mode
Heating for 'heat pump' type
Ventilator for 'cooling only' type
DRY
COOLING
button.
Desired temperature
23 °C
18 °C
23 °C