Probe Replacement; Battery Insertion And Replacement - Fluke FoodPro Plus Food Safety Thermometer User Manual

FoodPro Plus
Users Manual

Probe Replacement

The modular probe of the food safety thermometer is replaceable. To
replace probe, extend the probe partially to access the rubber caps.
Carefully pry up the rubber caps using a pin, and remove the screws using
a #2 cross-tip screwdriver as shown. Grasp the probe and carefully
separate the old probe from the probe base. Install the new probe in the
reverse order, firmly tightening the screws and replacing the rubber plugs.
The calibration accuracy of the unit is not affected by probe replacement
(Figure 14).

Battery Insertion and Replacement

To install a new 9V battery, remove the rubberized battery compartment
"plug" at the base of the unit by grasping the sides of the cover and pulling
straight out, exposing the battery. Gently shake or tap the base of the unit
on your palm to gain access to the battery. The 9V battery of the unit is
connected to the polarized snap connector (Figure 15).
Figure 15. Battery Insertion and Replacement
16
Figure 14. Probe Replacement
ebq17.eps
ebq18.eps