Teledyne 6000A Operating Instructions Manual page 29

Photometric Analyzer
Note: If you require highly accurate AUTO-CAL timing, use external
AUTO-CAL control where possible. The internal clock in the
Model 6000A is accurate to 2-3 %. Accordingly, internally
scheduled calibrations can vary 2-3 % per day.
To setup an
Choose System from the Function buttons. TheVFD will display five
subfunctions.
Select
Use < > arrows to blink
for
Press < > arrows to blink
won't be able to set OFF to ON if a zero interval is entered.) A
... (or
Use ∆ ∆ ∆ ∆ ∆ ∇ arrows to set an interval value, then use < > arrows to move to the
start-time value. Use ∆ ∆ ∆ ∆ ∆ ∇ arrows to set a start-time value.
To turn
System again, choose
values screen appears, use the < > arrows to blink the
and press Enter to go to the next screen. Use < > to select
∆ ∆ ∆ ∆ ∆ ∇ arrows to set the
because there is a nonzero span interval defined.
If instrument is turned off, the next time the instrument is powered, the
instrument will automatically perform a calibration cycle after 3 minutes of
entering the sample mode if AUTOCAL functions were on prior to shut down.
cycle:
and press the Enter Key
set appears.
...) screen appears.
the and/or
and press Enter again. When the
,
field to
Teledyne Analytical Instruments
, and press Enter . A new screen
), then press Enter again. (You
(or
cycles (to activate
. You can now turn these fields
Operation 3
): Press
(or )
field. Use
Part I 3-5