Screen Operating Procedure; Operation When Monaural Is Selected - Yamaha PM1D Supplementary Manual

The temporary monaural mode will be defeated, and the
PAN (BALANCE) will return to the positions specified
for the pair.
The MIX send PAN setting (or BALANCE setting)
will be set to the same position as TO ST.

Screen operating procedure

Here's how paired input channels/ST IN channels can be
temporarily set to monaural from within the screen.
1. Specify pairing for the desired adjacent odd-num-
bered/even-numbered input channels.
2. Access a screen (such as the IN HA/INSERT func-
tion) that shows the heart symbols, and for the
channels that you want to temporarily set to mon-
aural, click the pair/stereo indicator heart symbol
while you hold down the [SHIFT] switch of the data
entry block. Alternatively, move the cursor to the
heart symbol, then hold down the [SHIFT] switch
and press the [ENTER] switch.
The following popup window will appear.
Only the [SHIFT] switch of the data entry block
can be used to select the temporary monaural set-
ting from the screen.
Hint
If you click without holding down the [SHIFT]
switch, you will switch between conventional pair-
ing/monaural.
3. Move the cursor to the desired button, and press
the [ENTER] key. The setting will be made the
instant you press the [ENTER] key.

Operation when monaural is selected

The following points describe details of operation when
the L-MONO, R-MONO, or LR-MONO settings are
selected.
Input channels that are temporarily set to monaural
can be changed to L-MONO, R-MONO, LR-MONO,
pairing defeated, or paired settings. However, the
input signal of a ST IN channel cannot be set to
monaural (pairing defeated).
Temporary monaural setting for paired input channels/ST IN channels
Hint
In order to prevent accidents, it is possible to pro-
hibit the operator from using the [SEL] switches to
set/cancel pairing. To prohibit this, go to the PREF-
ERENCE screen and turn the PROHIBIT PAIR
CHANGE ON PANEL button on.
Each button has the following meaning.
If none of the above three buttons are on, the channels
will be paired.
When you make the monaural setting, the heart symbol
will change as follows.
L-MONO
Hint
The same type of popup window will appear if you
hold down the [SHIFT] switch and press the
[ENTER] switch on the heart symbol of an unpaired
channel. However, it will not be possible to select L-
MONO/R-MONO/LR-MONO.
4. To cancel the temporary monaural setting, hold
down the [SHIFT] switch and click the above heart
symbol once again, press the same button as you
selected in step 3, and press OK.
The monaural setting will be cancelled, and the PAN
(BALANCE) will return to its position at the time it
was paired.
Hint
By moving the cursor to a different button and press-
ing the [ENTER] switch, you can move to a different
channel for which to make temporary monaural set-
tings.
Also, pairing can be defeated in the usual way even if
channels are temporarily set to monaural.
When you return to a paired state after selecting tem-
porary monaural, the PAN setting and PAN mode
will return to the PAN/BALANCE position that had
been in effect when pairing was specified.
When the signal of an input channel is sent to a MIX
bus, any temporary monaural mode L-MONO, R-
MONO, or LR-MONO will operate in the same way
as normal monaural (pairing defeated) mode.
...............................Specify L-MONO
...............................Specify R-MONO
...............................Specify LR-MONO
R-MONO LR-MONO
Conventional
PAIR
11