Front Panel Operating Procedure - Yamaha PM1D Supplementary Manual

PM1D Manager for Windows Operating manual
Even if L-MONO or R-MONO is selected, you can
edit the parameters of the channel that was forced
off. (However, the [ON] switch will be fixed at Off
until you defeat the L-MONO or R-MONO setting,
and cannot be changed.)
A new preference setting [L,R-MONO SELECT ON
PANEL] has been added to the UTILITY function
PREFERENCE screen, allowing you to switch to the
LR-MONO setting from the front panel.

Front panel operating procedure

Here's how paired input channels/ST IN channels can be
temporarily set to monaural from the front panel.
1. Access the UTILITY function PREFERENCE
screen, and turn on the L,R-MONO SELECT ON
PANEL button.
This allows the temporary change from stereo to
monaural to be made from the front panel.
2. Specify pairing for any two adjacent odd-num-
bered/even-numbered input channels.
3. Use the front panel [SEL] switches and [SHIFT]
switches to select one of the following three ways in
which the channels will be temporarily set to mon-
aural.
• While holding down the [SHIFT]
switch Press and hold the [SEL]
switch of the odd-numbered (L)
channel ......................................... select L-MONO
• While holding down the [SHIFT]
switch Press and hold the [SEL]
switch of the even-numbered (R)
channel ........................................ select R-MONO
• While holding down the [SHIFT]
switch Press and hold the [SEL]
switches of both channels ............select LR-MONO
For the [SHIFT] switch described above, you may use
any of the [SHIFT] switches in CHANNEL SELECT sec-
tion of the SELECTED INPUT CHANNEL block or
SELECTED OUT CHANNEL block, or the [SHIFT]
switch of the data entry block.
10
In previous versions of the system software, it was
always possible to switch between PAIR and
MONO from the front panel. However, a new pref-
erence setting [PROHIBIT PAIR CHANGE ON
PANEL] has been added to the UTILITY function
PREFERENCE screen, allowing you to enable/dis-
able this function from being operated from the
front panel.
You can use the same procedure as described above to
change one temporary monaural setting to a different
temporary monaural setting.
On the panel, the INPUT [NAME] indicator will blink
alternately between the name of the channel that was set to
temporary monaural and the name of the monaural mode.
For a channel that is turned off, the INPUT [NAME] indi-
cator will dimly display the channel name. The [NAME]
indicator will also be displayed in the same way when these
channels are recalled to a DCA fader. For details on opera-
tion when a monaural setting is selected, refer to page 11.
• Name indicator
For L-MONO:
L ch
R ch
L ch: Alternately display
nel name (the brightness depends on the
on/off status)
R ch: Alternately display
nel name (dimly)
For R-MONO:
L ch
R ch
L ch: Alternately display
nel name (dimly)
R ch: Alternately display
nel name (the brightness depends on the
on/off status)
For LR-MONO:
L ch
R ch
L ch: Alternately display
nel name (the brightness depends on the
on/off status)
R ch: Alternately display
nel name (the brightness depends on the
on/off status)
4. To defeat the temporary monaural setting, press
the same combination of switches as you pressed in
step 3.
and the chan -
and the chan -
and the chan -
and the chan -
and the chan -
and the chan -