Connecting To A Computer; Usb Connection - Yamaha DME4io-C Owner's Manual

Connecting to a Computer

USB Connection

To connect multiple DME Satellite units to a network, you must assign appropriate IP addresses and make other
network settings on all units. To achieve this, you need to connect the [USB] connector of one of the DME Sat-
ellite units to the USB port of the computer using USB cables, install USB-MIDI Driver and DME Designer on
the computer, then assign the IP addresses to the DME Satellite units from DME Designer.
USB connections can be used in the following three ways:
(1) Set up the network (e.g., assign a unique IP address to each DME Satellite) from DME Designer.
(2) Control the group master DME Satellite from DME Designer.
(3) Connect to any individual DME Satellite and control that DME Satellite unit by transmitting MIDI com-
22
DME8i-C/DME8o-C/DME4io-C Owner's Manual
NOT E
• Refer to the separate DME Designer Installation Guide for details on installing USB-MIDI Driver and DME Designer.
• Make sure that the USB-MIDI Driver's THRU setting is "OFF."
• Refer to "Network Settings" on page 23 for more information on assigning IP addresses from DME Designer.
mands from a MIDI sequencer or similar software.
NOT E
• You can use DME Designer to control an entire device group through the group master.
• The correspondence between the MIDI commands to be received/transmitted and the scene parameters can be set up using
DME Designer.
• The USB port being used by DME Designer is not available for use by a MIDI sequencer or other application.
Device Group
USB
DME Satellite
USB Cable
Group Master
USB
DME Satellite
Ethernet Cable
Switching Hub
Ethernet
Ethernet Cable
Straight Cable
INPUT
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL DIGITAL MIXING ENGINE SATELLITE
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL
INPUT
SCENE SCENE HOME HOME UTILITY UTILITY
INPUT
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL DIGITAL MIXING ENGINE SATELLITE
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL
INPUT
Computer
(Running DME Designer.)
DME64N/24N
LEVEL LEVEL MUTE MUTE CANCEL CANCEL ENTER ENTER
(Running MIDI
USB Cable
Sequencer or
similar application.)
Computer