Connecting The Ls9 To A Computer - Yamaha LS9 Quick Start Manual

Connecting the LS9 to a Computer

Using a computer on which the LS9 Editor software has been installed you can edit and save LS9 scene memory and
library data (offline editing). The LS9 can be connected to the computer via an Ethernet cable for data transfer and
synchronization, allowing the computer to function as a remote controller for the LS9�
● Preparing for Connection
You will need the software and hardware listed below�
Prepare these items in advance�
Software
Download the following software and drivers from the Yamaha Pro Audio website (see below):
1) Studio manager Host software.
) LS9 Editor software.
) DME-N Network Driver.
Follow the supplied and on-screen instructions, and install the above software on your computer.
The latest versions of the software items listed above can be
downloaded without charge from the Yamaha Pro Audio website:
http://www.yamaproaudio.com/
Hardware
Your computer system must meet the following minimum hardware requirements:
CPU: 800 MHz or higher Intel Pentium or Celeron family processor.
OS: Windows XP Home Edition or XP Professional.
Hard Disk: 0 MB or more free space required.
RAM: 56 MB or more.
Display: 104 x 768 pixels, 16-bit High Color or better.
Others
Communication Cable: Ethernet CAT5 cable (high-quality cable preferred).
● Connecting the LS9 to Your Computer
Connect the LS9 to your computer either directly or via a switching hub using a high-quality CAT5 Ethernet cable� Either a
straight or cross Ethernet cable can be used when connecting the LS9 directly to the computer�
Press the SETUP key in the DISPLAY ACCESS section as many times as necessary until the MISC SETUP display appears� The LINK
MODE, IP ADDRESS, GATEWAY ADDRESS, SUBNET MASK, and MAC ADDRESS parameters should appear in the NETWORK field
in the MISC SETUP display. Please note that only class-C IP addresses (the first three digits are 192 ~ 223) are supported.
CAT5 Ethernet Cable
15