Troubleshooting - Sharp UX-144 Operation Manual

1
Problem
I
Check and remedy
,
!
Nothing appears on the display.
~ c Make sure the power cord is properly connected. ~
,
Make sure the power switch has been switched to the
I
I
correct position.
e Connect another electrical appliance to the outlet to
confirm that it is live.
The machine does not respond ,
If a beep sound is not made when the keys are
to any key operation.
pressed, turn off the power and then turn it back on
I
I
several seconds later.
Automatic document feeding I
Check the size of the document (see "Transmittable
does not work (for transmission
documents" in Chapter 4).
or copying).
I
Dialling cannot be performed. ~
Make sure the power is on for Automatic Dialling.
Make sure that the line is properly connected to the
~
jack.
I
Make sure that the setting of the DIAL switch is
I
correct (tone "T"or pulse "P").
Nothing is printed at the
I
Make sure that the document for transmission is
receiving end.
placed face down in the feeder.
\
Make sure that the recording paper is properly loaded
I
at the receiving machine.
I
The power is on, but no
~ . Make sure that the receiving machine has recording
transmission takes place.
I
paper.
I
If the receiving machine is in manual mode with no
attendant, reception will not be possible.
s If the receiving machine is not a Sharp model, make
sure it is G3 compatible.
s Check the display for error messages.
I . Pick
Up the handset
and check for a dial tone.
I
A distorted image is received at '.
Noise on the telephone line may cause distortion. Try
the other end.
sending the document again.
~ . Make a COpyof the document on your machine. if the
I
copy is also distorted. your machine may have a
problem. If the problem persists, call for service.
,
TROUBLESHOOTING 9-1