Mitel 3000 Manual page 75

Mitel 3000
Broadband Module Manual
Current security triggers are displayed. There is an option to delete each entry.
Select New Trigger.
(Right side of picture cut off.)
Enter the following parameters
Transport Type
Port Number Start
Port Number End
Secondary Port Number
Start
Secondary Port Number
End
Allow Multiple Hosts
Max Activity Interval
Enable Session Chaining
72
Adds a trigger for a TCP or UDP application.
Sets the start of the trigger port range for the control
session.
Sets the end of the trigger port range for the control
session.
Sets the start port range that the trigger will open.
Sets the end of the port range that the trigger will open.
Allow or Block sets whether or not a secondary session can
be initiated to/from different remote hosts or the same
remote host on an existing trigger.
The max interval time in milliseconds between the use of
the secondary port sessions. If a secondary port opened by
a trigger has not been used for the specified time, it is
closed.
If this is enabled, TCP dynamic sessions also become
triggering sessions, which allows multi-level session
triggering.