Setting Up The Wireless Lan (Wlan); Wlan Range; Quick Setup To Wlan Without Security - Mitel 3000 Manual

Broadband module

Hide thumbs Also See for 3000:

Table of Contents

The ISDN setup is now complete.

SETTING UP THE WIRELESS LAN (WLAN)

The Broadband Module is equipped with a Wireless LAN and can connect to PCs that are

equipped with a wireless interface.

For security reasons the WLAN is located on the DMZ by default. If you have a

combination of wired and wireless PCs connected to the module it is

recommended that the WLAN be relocated to the LAN. This should only be done

when the security on the WLAN is programmed. See page 49 for programming

WARNING

security and page 46 for relocating the WLAN.

Wireless LAN speed drops the further the wireless device is away from the Broadband

Module. If there is a clear line of sight between the Broadband Module and the wireless

device it can operate at reduced speeds at up to about 90m (300 feet). However this range is

reduced if there is no clear line of sight between the module and the wireless device.

This procedure should only be used to setup and test WLAN connectivity. When this

procedure has been completed and WLAN connectivity has been established, go to the next

section - Setting Up WLAN With Security on page 48 and complete the process.

Mitel 3000

Broadband Module Manual

Table of Contents