Operating the 810 Scaler
Changing the aspect ratio
•
Press Aspect on the remote control.
The Aspect menu will be displayed:
•
Press A or V to highlight the aspect ratio you want
to select.
Press Enter.
•
The current aspect ratio will be indicated by a red bar.
The options are explained in the following table:
Option
Description
Full
Uses all pixels of the projector by converting
the 16:9 aspect ratio to 17:10, resulting
in a 5% horizontal stretch which is usually
unnoticeable.
16:9
Displays a 16:9 image. There will be black
bars above and below the image.
4:3
Displays a 4:3 image. There will be black
bars each side of the image.
2.35:1
Anamorphic widescreen; only available with
an anamorphic lens.
Changing the focus
Press Focus + or - on the remote control.
•
Hiding the video image
Press Hide on the remote control.
•
Press Hide again to reveal the image.
•
Selecting a source
•
Press Source on the remote control.
The Source menu shows a list of enabled sources:
•
Press A or V to highlight the source you want to
select.
Press Enter.
•
The current source will be indicated by a red bar.
Displaying a test pattern
•
Press Pattern on the remote control.
This steps through the available patterns.
Zooming the image
•
Press Zoom T or W on the remote control.
T (Tele) zooms in. W (Wide) zooms out.
Displaying information
•
Press Info on the remote control.
Displays the input rate, input source, preset mode, and
aspect ratio on the on-screen display.
41
Operating the 810
System