Meridian 810 User Manual page 27

Step 4
Once the lens is screwed firmly home:
• Undo the three collar clamp screws fully and rotate
lens until correctly aligned.
• Tighten all three collar clamp screws and the
additional fourth single clamp screw located at rear of
the mounting collar.
Use the 2mm Allen key for all screws.
Step 5
Anamorphic Lens
Assembly
M6 Adjustment
screws
4th Single Clamp
Screw Position
The entire anamorphic lens assembly can be adjusted
out (away from the projector), in (towards the
projector), and left and right, by loosening the M6
screws with the supplied 4mm Allen key.
Step 6
Connect the anamorphic lens assembly connector box
to the 810 Scaler, as shown in the following diagram.
'Left' & 'Right' direction
Connector box
19
Installing the 810
Projector