28
Setting up the 810
Configuration Wizard
System
The Configuration Wizard leads you through the correct
sequence to configure your Scaler/Projector.
Alternatively, you can skip between the configuration
stages, which allow you to reset the configuration, or
configure the sources or other settings of the Scaler/
Projector.
To run the Configuration Wizard
•
If necessary press Power to put the scaler into
standby.
•
Press More.
The display shows:
•
Press Wizard.
Follow the sequence of configuration stages described
in the following pages, pressing Next to proceed after
completing each stage.
At any stage in the Configuration Wizard the following
options are available:
To do this
Go back to an earlier configuration option
Go to the next configuration option
Return to the title screen for the stage
Exit from the configuration menus
Press
Back
Skip
Home
Power