Projector Settings - Meridian 810 User Manual

Projector settings

The following table summarises the projector settings:
Setting Values
Off, Colour bars,
Test Pattern
Crosshatch 1,
Crosshatch 2,
Staircase, Ramp, Flat.
Display Mode Cross, Single, Double.
Input Levels Standard or
Enhanced.
Lamp Power 80%, 83%, 86%, 89%,
91%, 94%, 97%, 100%.
Back Colour Black or Blue.
Frame Lock Off or On.
Off or On.
Flip H, Flip V
Gamma B, C, A.
Force Signal 1 to 6 or Off.
Default Description
Off
Displays a test pattern.
Cross Single displays just the input from DVI 1 ; this option is useful
when connecting a source such as a PCs. Double displays
the input from DVI 1 on the left and DVI 3 on the right. Cross
displays DVI 1 top left, DVI 2 top right, DVI 3 bottom left, and
DVI 4 bottom right.
Standard Standard is appropriate for input levels of 0 to 255.
Enhanced is for input levels of between 16 and 235.
80% Specifies the lamp power. The lamp life will be extended at
lower powers.
Black Specifies the background colour.
Off This synchronizes all video input signals for picture projection.
Off, Off
Allows you to compensate for an inverted image; eg if the
projector is behind the screen.
B Sets the Gamma to A: 2.2, B: 1.8, or C: 2.6. The system is
calibrated for a Gamma of 1.8.
6 Should be set to 6 for use with the 810 scaler. When
connecting a PC directly to the projector another setting may be
required:
1: 4096x2400, None, Dual: 1 screen, Dual Link
2: 4096x2400, None, Single: 1 screen, Single Link
3: 2048x2400, 2Stripe, Dual: 2 screens, Dual Link
4: 2048x2400, 2Stripe, Single: 2 screens, Single Link
5: 2048x1200, Cross, Dual: Centre cross, Dual Link
6: 2048x1200, Cross, Single: Centre cross, Single Link
7: 1024x2400, 4Stripe, Dual: Stripes, Dual Link
8: 1024x2400, 4Stripe, Single: Stripes, Single Link
31
Setting up the 810
System