Anamorphic Lens And Actuator Assembly - Meridian 810 User Manual

18
Installing the 810

Anamorphic lens and actuator assembly

Projector
The following instructions explain how to fit the optional
anamorphic lens to the Meridian 810 Projector.
Please refer to the Iscoscope Owner and Setup Guide
for setting up the anamorphic lens assembly.
Components
The anamorphic lens kit includes these components:
• Shelf assembly (sled and fixing bracket)
• Lens (in case)
• Assembly guide
• Isco user guide
• Accessories box which includes: Allen keys, Remote
control, Power supply unit with adapters, Jack plug
kit, Fixings and washers
Step 1
• Remove the dust caps from the four mounting
positions.
• Position the shelf.
• Screw in the M10 button head screws using the
supplied 6mm Allen key.
Use the upper fixing positions when the projector is
mounted above the screen centre line.
M10 Button Head Screw & Washer
(4 places)
Step 2
Collar Clamp
Screw positions
• Loosen off the three collar clamp screws until they
are little more than finger tight using the supplied
2mm Allen key.
Step 3
Collar
Anamorphic Lens
• Screw the anamorphic lens into the collar.
If the three collar clamp screws are not loosened to
finger tight, the anamorphic lens will be difficult and
tight to screw home.