Maytag 4348178 Use And Care Manual page 12

TO SET A CLEAN CYCLE
The self-cleaning cycle
IS
preprogramed for 3112 hours. You can also set
the electronrc oven control for a delayed start of the clean cycle.
To self-clean:
1 Slrde the door lock handle lo the right You may need to press the
door slrghlly lo gel
it
lo lock properly
Never try lo force the door lock handle. Forcrng the handle may
damage the door lockrng machantsm
2. Push CLEAN button, The oven begins lo heat wrthrn 2 seconds
Note: You can find out when the clean cycle WIII be frnrshed by pushrng
the STOP TIME button
To use delayed self-clean:
1 Push STOP TIME button
2
!!
Turn SET knob lo trme of day when you wash cleanrng to be completed
(must be more than 3% hours later than current lime of day).
9
3. Slide Iha door lock handle lo the right. You may need
to press
the
door slightly to get if lo lock properly. Never try lo force the door
lock handle. Forcing the handle may damage the door locking
u
mechanism.
s
4
Push CLEAN bunon.
Note: Dunng a delayed self-clean operation you can find ou1 when the
P
oven turns on by pushing and holdrng the CLEAN button.
12
TO STOP A CLEAN CYCLE:
1 Press the OVEN CANCEL button
2 Walt until the oven has cooled below the lockrng temperature (20-30
mrnutes) and the word LOCK IS OH In the Electronrc Range Control
jrsptay
3 Strde the door handle lett to unlock the door You WI/ no1 be able to
unlock the oven unless the oven temperature IS at a sale tevet Never
force the door lo&unlock handle
WHEN A CLEAN CYCLE IS FINISHED
1
2
Wart until the oven has cooled below lockrng lemperature (20-30
mrnutes) and the word LOCK IS oft rn the Electronrc Range Conlrol
drsptay
Sltde the door IocWhandle lefl to unlock the door. You wrll not be able
lo unlock rhe oven unless the oven lemperalure IS al a sale level. Never
force the door lock handle.
Note: If the door does not unlock because Ihe temperature has not had
trme lo drop to a safe level when you ftrst try lo open the door, be sure
lo sltde the door lockfunlock handle back all the way lo the righl
AFTER A CLEAN CYCLE
After a clean cycle, you may nolrce some whrte ash rn the oven Just wrpe
it
up wrlh a damp cloth
If whrte spots remain. remove them wrth a soap-filled steel wool pad Be
sure lo rinse thoroughly wrth a vrnegar and waler mrxlure. These deposits
are usually a salt resrdue lhat can not be removed by the clean cycle
II Ihe oven IS not clean after one clean cycle, the cycle may be repealed