Clock Operation And Minute Minder - Maytag Chambers CMO-2743 Use And Care Manual

CLOCK OPERATION AND MINUTE MINDER
Your oven has two time of day clocks. The digital clock on the upper control
panel controls all timed operations in the lower oven. The electronic clock
located in the microwave control panel controls the microwave oven.
How to Set Clocks:
Digital Clock
Push in and turn the Minute Minder timer knob to the left until the correct
time appears. NOTE: The timer hand will also turn. Reset this hand by
turning the knob (do not push the knob in) to the "OFF" position.
Electronic Clock
1. Touch "CLEAR" pad.
2. Touch "TIME OF DAY" pad.
3. Enter numbers on control panel to indicate a time one minute
faster than time on digital clock.
4. When digital clock registers the same time as numbers touched
on microwave control panel, touch "TIME OF DAY" pad again
NOTE: Flashing lights in the display panel of the microwave
oven indicate that there has been a power interruption to the
microwave oven. Power to the microwave oven is interrupted
when the selector is moved into or through the "CLEAN" po-
sition or when there is an electrical power failure.
If the clock is stopped for 18 hours or more, customer programmed recipes
may be lost. The preprogrammed recipes will not be affected. Follow above
instructions to reset both clocks, since power interruption will also affect
the digital clock.
The two clocks operate independently and if they occasionally get out of
phase with the other, there is no cause for alarm - simply reset the elec-
tronic clock as indicated above.
How to use the Minute Minder:
The Minute Minder is located on the left side of the clock. To use the Minute
Minder, turn the knob to the right until the white hand points to the desired
number of minutes, up to a maximum of 60. At the end of the set time, a
buzzer will sound and the white hand will point to "0." After the buzzer
signal, turn the knob until the white hand points to "OFF." This is a re-
minder only and will not turn the oven "ON" or "OFF."