Advertisement
18.
14
. Use a brush and liauid
detergent to test all gas connections for
leaks. Bubbles around connections will
indicate a leak. If a leak appears, shut off
gas valve controls and adjust
connections. Then check connections
again.
NEVER TEST FOR GAS LEAKS
WITH A MATCH OR OTHER FLAME.
Clean all detergent solution from oven.
r
Personal Injury/
Product Damage Hazard
Securely fasten oven to cabinet using
four of the six screws provided.
Failure to do so could cause the oven
to move or tip during use and result
in personal injury or product damage.
15
. Center oven in cabinet cutout.
Use 2 screws through the mounting
holes in upper corners of oven frame,
and 2 screws through mounting holes in
lower front frame channels to secure
oven to cabinet (or filler strips). Do Not
overtighten screws.
16
. To replace
oven door, grasp
sides of door firmly.
Place top of hinge
arms against top of
openings in oven
frame. Push bottom
of door in until
hinges are all the way into the
openings. Gently lower door so that
bottom of hinge arms rest on bottom of
openings. Open door fully. Replace
retaining brackets and screws. Close
door completely. If door does not line up
with oven frame, remove door and
repeat above steps.
Panel D
15. 23.
Electronic Ignition System -
initial lighting and gas flame
adjustments.
Oven burner uses an electronic ignitor in
place of a standing pilot. When the oven
control knob is turned to the desired
setting, a glow bar heats to bright
orange and ignites the gas. No sparking
occurs and the glow bar remains on
while the burner operates.
II)
ab
Lift tab located at the center of the rear
of the oven bottom. Remove oven
bottom.
Power Failure
Do Not attempt to operate the oven
in the event of a power failure. If a
power failure should occur during
cooking operation, turn the oven
control to the off position.
Failure to turn the oven control off
will result in oven operation upon
resumption of power to the unit.
18
. Check the operation of the oven
burner. Push in and turn the oven control
knob to 300°F. The oven burner should
light in 50
to
60 seconds. This delay is
normal because the oven safety valve
requires time to open and allow gas to
flow.
Product Damage
Do Not insert any object into the
openings of the protective shield that
surrounds the ignitor.
I
Do Not clean the area.
Failure to follow these instructions
could result in product damage.
19
. Check the oven burner
for proper flame. This flame
should be 112' long, with inner
cone of bluish-green, and outer
Numbers
correspond
to steps.
.
16.
mantle of dark blue, and should be clean
and soft in character. No yellow tips,
blowing or lifting of flame should occur.
air shutter
-
orifice
hood
20
. If oven flame needs to be
adjusted, locate air shutter in the storage
drawer opening near center rear of oven.
Loosen screw and adjust the air shutter
until the proper flame appears. Tighten
air shutter screw.
2
oven bottom. Place oven bottom in
oven so that tab can be inserted into
slot at the rear of the burner area.
Replace oven racks.
22
. Grasp front of broiler drawer
and place guides into tracks. Lift front of
drawer so that drawer will go over
drawer stops. Close drawer.
. Use two screws to attach air
grille to oven cabinet if there is a gap
between oven and bottom of oven
cabinet cutout. If there is no gap,
attaching the air grille is optional.
Congratulations!
You have just finished installing
your new wall oven. Keep
Installation
Instructions
close to
oven for easy reference.
Advertisement
