Interrupting A Copy Run - Sharp AR-5015 Operation Manual

INTERRUPTING A COPY RUN

INTERRUPT is used to interrupt a long copy run so that another job can be
done.
Downloaded from: http://www.usersmanualguide.com/
Press the INTERRUPT (
1
The copier will return to the initial settings.
If this copier has been programmed in the auditing mode using user
program No. 10, "–––" will appear in the copy quantity display. Enter
your account number using the numeric keys. The number of copies
of the interrupt copying will be accumulated against this account
number. See page 13.
When the copier stops, remove the original and set the
2
original for interrupt copying.
Select the desired available copier functions.
3
Set the number of copies.
4
Press the START (
5
When all INTERRUPT copies are finished, press the
6
INTERRUPT ( ) key again to cancel the INTERRUPT
mode, and remove the original used for interrupt copying.
The previous copy quantity, copy ratio, copy density, and paper size
will be automatically restored.
Replace the original for the interrupted job on the original
7
table and press the START (
) key.
) key.
) key.
25