Cloning Overview / Clonable Menu Features - LG 32LD330H Owner's Manual

IMPORTANT CLONING INFORMATION
There are three options for cloning a Master TV Setup:
• Using a USB memory device
• Using a TLL-1100A clone programmer
• Using a LT2002 clone programmer
Each option is described in further detail on the pages
that follow. As you perform cloning procedures, be sure
to complete each task as indicated. If a procedure or
step is omitted or not performed completely, cloning
may not work. At each step, pay attention to ensure
the TV screen shows the proper message when
cloning. If the message indicated does not appear,
there is a problem with that step, and cloning may not
be successful.
Warning: Copying a blank or incorrect
memory into a TV will cause the TV to
operate erratically or become inoperable.
Warning: Do not connect a clone program-
mer to a PPV card installed in the Master
or Target TVs. Also, if the TV is in
LodgeNet PPV Mode (check with the site
administrator if you are not certain), do not
connect a clone programmer to the GAME
CONTROL/MPI port. Either of these actions
will damage the clone programmer and, if
applicable, the PPV card.
Clonable Menu Features
Installer Menu
Installer Menu item settings
Channel
Auto Tuning (Channel Lineup)
Manual Tuning
Channel Edit
Channel Label
Picture
Aspect Ratio
Picture Mode
Advanced Control
Note: Some menu options vary between analog and digital channels and Aux sources.
206-4186

Cloning Overview / Clonable Menu Features

Before you begin cloning:
• Complete the Commercial Mode Setup for Master TV procedure
on pages 12 to 13.
• All equipment should be connected to power and turned ON.
• Both the Master and Target TVs must be in Pass-through
Mode.
• Ensure Installer Menu items on Target TVs are set/restored to
factory default settings (i.e., set Installer Menu item 117 FACT
DEFAULT to 001 on Target TVs) before Teaching is initiated.
• Learning and Teaching is only possible between identical
model TVs.
• If using a USB memory device, ensure the USB device has
been formatted with FAT format.
• For both Master and Target TVs—If using a clone programmer,
ensure the TV signal source is either an Aux or TV (RF) source.
If a TV (RF) source, the TV must be tuned to an analog (not a
digital) channel.
• LT2002 only—Make sure the batteries in the clone programmer
are fresh. If batteries are removed, the clone programmer clock
time (if set) will be lost (see page 28 for information on the clone
programmer clock).
• Do not unplug the TV power cord or remove/disconnect the
USB memory device/clone programmer while Learning or
Teaching, as doing so may cause the TV to malfunction or
harm the USB device/clone programmer, respectively.
Audio
Auto Volume
Clear Voice
Sound Mode
Balance
TV Speaker
Option
Menu Language
Audio Language
Caption
Caption Mode
Digital Caption Options
Lock
Movie Rating
TV Rating – Children
TV Rating – General
Input Block
Time
Auto Clock
Manual Clock
Off Time
On Time
Auto Off (Sleep Timer)
23