LG 32LD330H Owner's Manual page 156

The b-LAN module is internal to the TV. It allows the hotel/institution head end equipment to communicate, via
the institution's RF distribution system, with the TV for configuration and control.
Note: MPI cards with b-LAN technology—LMT7Z5, LMT7Z7, LMT7Z9—are NOT supported on TVs in which the
b-LAN module is embedded.
Power to the b-LAN module is controlled by Installer Menu item 118 POWER SAVINGS. The default value is
003—the b-LAN module is only powered when the TV is turned ON. See chart below.
POWER
SAVINGS
003 (default)
The control device at the head end, for example, an LG FMA-LG101, can control multiple TVs. When the TV is
first installed, it must be turned ON in order for the head end to be able to communicate with the b-LAN. At this
point, if it is desired for the b-LAN to always be powered, including while the TV is in Standby, set Installer Menu
item 118 POWER SAVINGS to 001.
If the embedded b-LAN will not be used, enable maximum power savings in both Standby and TV Power On
Mode by setting Installer Menu item 118 POWER SAVINGS to 007.
206-4163
TV Standby State
b-LAN Power
001
007
Reference: b-LAN Setup & Overview
TV Power On State
b-LAN Power
On
Off
Off
On
On
Off
39