Performance Edit; A Performance's Structure And Settings; Major Performance Edit Parameters - Korg PS60 Owner's Manual

Performance edit

A performance's structure and
settings
A performance consists of the sound sources "main
timbres" and "sub timbres," and the "master effect"
and "EQ" sections that apply effects to the overall
sound and adjust its tonal character.
A "program" is assigned to each timbre; "tone
parameters" adjust the sound of this program, and
"timbre parameters" specify how the timbre will
operate.
Each program (except for the STRINGS timbre) has
one "insert effect." Insert effect settings are made in
Program Edit mode.
Major performance edit
parameters
Tone parameter adjustments
Each timbre has eight tone parameters (located in
"Filter/Amp:" and "Filter/Amp EG:"); these allow you
to make overall adjustments to the brightness, attack,
and decay speed of the selected program (p. 31).
Structure of a performance
A.PIANO
TimbreParameters
Program
E.PIANO
TimbreParameters
Program
ORGAN
TimbreParameters
Program
STRINGS
TimbreParameters
Program
BRASS
TimbreParameters
Program
SYNTH
TimbreParameters
Program
MAIN TIMBRES
SUB TIMBRES
(used only with split settings)
Performance edit A performance's structure and settings
L/MONO, R
Tone Parameters
SEND1
IFX
SEND2
L/MONO, R
Tone Parameters
SEND1
IFX
SEND2
L/MONO, R
Tone Parameters
SEND1
IFX
SEND2
L/MONO, R
Tone Parameters
SEND1
SEND2
L/MONO, R
Tone Parameters
SEND1
IFX
SEND2
L/MONO, R
Tone Parameters
SEND1
IFX
SEND2
Timbre parameter settings
You can make the following settings for each timbre.
• Adjust the volume and pan.
"Volume," "Pan (Pre)," "Pan (Post)" (p. 30)
• Adjust the pitch/tuning.
"Octave," "Transpose," "Detune" (p. 31)
• Switch the portamento on/off and adjust its speed.
"Portamento" (p. 31)
Portamento is a function that creates a smooth
change in pitch between notes when you play a note
before releasing the previous note.
• Specify the amount of pitch change that can be
produced by moving the joystick to left or right.
"Bend Range" (p. 31)
• Specify whether the damper effect will be applied
to each timbre.
"MIDI Filter:" (p. 32)
• Specify whether each timbre can be played by an
external MIDI device, or whether each timbre can
play an external MIDI sound module.
"Status" (p. 30)
MODULATION
Chain
On/Off
REVERB/DELAY
Return2 Return1
Master
Volume
AUDIO OUTPUT
EQ
L/MONO, R
27