Removal For The Focus Shaft Assembly - 1500 And 2000 Projectors Only - Kodak Ektalite 500 Service Manual

SERVICE MANUAL
23JUL01
Removal for the FOCUS SHAFT ASSEMBLY - 1500 and
SM5766-1
Page
2000 PROJECTORS Only
36 of 96
Warning
Dangerous Voltage
1 Disconnect the main power.
2 Do the removal for the LOWER HOUSING ASSEMBLY.
3 Disconnect the 3 CONNECTORS on the MAIN BOARD. It is not necessary to disconnect
the CONNECTOR next to the LOWER LIGHT BAFFLE ASSEMBLY.
4 Lift the MAIN BOARD up.
5 Remove the FOCUS KNOB.
6 Remove the short, gray wire from the AUTO-FOCUS DEFEAT SWITCH.
Important
It is necessary to push the AUTO-FOCUS BRACKET backward and forward to allow access
to the SCREWS on the LENS MOUNT ASSEMBLY.
7 Remove the 3 SCREWS from the LENS MOUNT ASSEMBLY.
8 Lift and remove the LENS MOUNT ASSEMBLY.
9 Remove the FOCUS SHAFT SPRING from the LENS MOUNT BRACKET.
10 Remove the SPRING from the CLAMP LEVER on the LENS MOUNT BRACKET.
11 Remove the SPRING from the PHOTOCELL BRACKET.
12 Remove the E-RING and SPACER from the FOCUS SHAFT ASSEMBLY.
13 Remove the SCREW from the LENS SUPPORT BRACKET.
14 Lift and remove the LENS SUPPORT BRACKET.
15 Remove the AUTO-FOCUS SWITCH ASSEMBLY.
16 Remove the SCREW from the RACK SOLENOID ASSEMBLY.
Removals and Installations