SERVICE MANUAL
23JUL01
Removal for the AUTO-FOCUS BRACKET ASSEMBLY - 1500 and
SM5766-1
Page
2000 PROJECTORS Only
23 of 96
Warning
Dangerous Voltage
1
Disconnect the main power.
Important
There is no AUTO-FOCUS BRACKET ASSEMBLY for the Model 1000.
2
Do the removal for the LOWER HOUSING ASSEMBLY.
3
Disconnect the 3 CONNECTORS on the MAIN BOARD. It is not necessary to disconnect
the CONNECTORS next to the LOWER LIGHT BAFFLE ASSEMBLY.
4
Lift the MAIN BOARD up.
5
Cut and remove the necessary WIRE TIES.
6
Disconnect the 2 violet wires from the CYCLE SOLENOID on the SMALL BOARD.
7
Pull the SMALL BOARD up.
8
Do the removal for the MECHANISM ASSEMBLY.
9
Remove the Torx SCREW from the WORM PULLEY.
10
Remove the WORM PULLEY.
11
Remove the 2 Torx SCREWS from the CYCLE SOLENOID.
12
Remove the CYCLE SOLENOID.
13
Remove the Phillips SCREW from the AUTO-FOCUS BRACKET ASSEMBLY.
14
Pull and remove the AUTO-FOCUS BRACKET ASSEMBLY through the hole where the
CYCLE SOLENOID was located.
Removals and Installations