Table of Contents
Advertisement
Briefly press the forward
or reverse
button to change
slides in the desired direction. You must press the reverse
button firmly.
FOCUS
Let the projector warm up for about 30 seconds. Focus for
maximum sharpness at the center of the screen image by
rotating the Focus KNoB. You will need to focus only the first
picture if all slides are in the same type of mount.
Under special conditions—for example, when you are
projecting slides in intermixed types of slide mounts—you
may need to readjust the focus manually.
To demonstrate
extreme
focus
changes,
place card-
board-mounted slides in the tray with every other slide in
backwards. You can see the action of the automatic focus
system by watching the movement of the focus knob or by
watching the screen image.
NOTE: A matte-surface (write-on) slide or a mount with-
out film can cause the focus motor to run continuously.
LEVELING
FOOT
AUTOMATIC
TIMER
The automatic timer has four settings—M
(manual), 5, 8,
and
15 (seconds). Set the AUTOMATIC-TIMER
SLIDE for the
number of seconds you desire and the projector will change
slides automatically.
Set the automatic-timer
slide at M
for manual operation. (You can interrupt the automatic op-
eration at any time by use of the forward or reverse button
on the projector or on the remote control.)
REMOTE CONTROL
The remote control has both FOR (forward) and REV (re-
verse) buttons for controlling the direction in which the
slide tray rotates. Briefly press either the forward or the
reverse button to change slides in the desired direction.
You must press the reverse button firmly.
IMPORTANT: If you do not press the reverse button
firmly, the tray may rotate in a forward direction.
AUTOMATIC-TIMER
SLIDE
Advertisement
Table of Contents
