Removal For The Fan Shaft Assembly - Kodak Ektalite 500 Service Manual

SERVICE MANUAL
23JUL01

Removal for the FAN SHAFT ASSEMBLY

SM5766-1
Page
7 of 96
Warning
Dangerous Voltage
1 Disconnect the main power.
2 Do the removal for the LOWER HOUSING.
3 Lift the TRANSFORMER up.
4 Lift the POWER MODULE up.
5 Cut the 3 WIRE TIES:
• 1 on BLOWER COVER wires
• 2 on SMALL BOARD between the MOTOR and MECHANISM ASSEMBLY
6 Disconnect the 2 violet wires from the CYCLE SOLENOID on the SMALL BOARD.
7 Pull the SMALL BOARD up.
8 Remove the Torx SCREW from the BLOWER COVER ASSEMBLY.
9 Lift the GRILL ASSEMBLY in front of the BLOWER COVER ASSEMBLY up.
10 Loosen the Torx SCREW on the right track of the LOWER LIGHT BAFFLE ASSEMBLY
approximately half way.
11 Lift the LOWER LIGHT BAFFLE ASSEMBLY off the TAB on the BLOWER COVER
ASSEMBLY.
Removals and Installations