Kodak i3200 User Manual page 41

Problem
Scanner pauses excessively during
scanning
Roller marks or streaks appear on
documents after scanning
Vertical lines appear on the image
Documents are multifeeding
U3 is displayed in the operator control
panel
A-61771 March 2013
Make sure that:
• the host computer meets minimum requirements for scanning.
• there is enough free space on the hard disk drive.
• all other applications are closed.
• you are using a USB 2.0 (or higher) connection.
You can also try changing the scanning options (compression, etc.) in
your scanning application.
Clean the feed module, transport rollers and separation roller and tires.
Refer to Chapter 5, Maintenance.
• Clean the imaging guides. Refer to Chapter 5, Maintenance.
• Enable the Streak Filter option or increase the aggressiveness.
Make sure that:
• the leading edges of all batched documents are centered in the feeder
so that each document will come in contact with the feed rollers.
• the feed module and separation roller are clean and not worn.
• documents with an unusual texture or surface are fed manually.
• the gap release is not in the vertical position.
The document(s) you are trying to scan is too long.
• Verify that the Document Management: Maximum Length option on
the Device-General tab (TWAIN Datasource) or the Longest
Document option on the Scanner tab (ISIS Driver) is set to longer than
the longest document being scanned. The default is 17 inches /
43.2 cm.
• Decrease the resolution.
Possible Solution
6-3