Kodak i3200 User Manual page 15

2-4
Getting your documents ready to scan
• Standard paper size documents feed easily through the scanner. When
organizing your documents for scanning, stack the documents so the lead
edges are aligned and centered in the input tray. This allows the feeder to
introduce documents into the scanner one at a time.
• Remove all staples and paper clips before scanning. Staples and paper clips
on documents may damage the scanner and documents.
• All inks and correction fluids on the paper must be dry before scanning is
started.
• Torn, damaged or crushed pages can be transported successfully through
the scanner. However, no scanner can transport every possible type of
damaged paper. If in doubt about whether a specific damaged document
can be transported through the scanner, you can place the document in a
clear protective sleeve and use the rear document exit or use the optional
Kodak Flatbed Accessory. Sleeves should be manually fed, one at a time,
folded edge first, when using the gap release or the rear document exit.
4. Place the documents you want to scan in the input tray. If you are scanning
one-sided documents, be sure the side you want to scan is facing up.
NOTE: Some very thick and/or stiff documents; such as shipping envelopes,
may require the following:
• Use of the rear document exit.
• Use of the gap release.
• Scanning at 400 dpi or more to reduce the scanner transport
speed.
5. When 1 - Color PDF is displayed on the operator control panel, press the
Start/Resume/Pause button.
A-61771 March 2013