Lfe (Low Frequency Effect) Level; Lip Sync; Aps (Auto Power Save) - Kenwood RV-7000 Instruction Manual

Speaker setup (Detailed Setup)

LFE (Low Frequency Effect) Level

LFE (Low Frequency Effect) Level
Low frequency effect signal is used exclusively for giving the field
effect of bass tone in the Dolby Digital and DTS signal.
1
Select "LFE LVL".
[SETUP]
[MULTI CONTROL ∞/5]
[SETUP]
2
Set the LFE level.
Use [MULTI CONTROL ∞/5] to select the LFE level.
[SETUP]
The level is adjusted from 0dB to -10dB in1dB step
decrements.
3
Go to the next setting.

Lip Sync

Lip Sync
If the monitored video is delayed in time with respect to the
audio from the speakers, the audio output timing can be delayed.
1
Select "LIP SYNC".
[SETUP]
[MULTI CONTROL ∞/5]
[SETUP]
2
Set the delay time.
Use [MULTI CONTROL ∞/5] to select the delay time.
[SETUP]
The delay time is adjusted from 0ms to 300ms in 10ms step.
3
Go to the next setting.
32
RV-7000/RV-6000/RA-5000
6 0 - 5 8 2 7 - 0 8 _ 0 0 _ E n . i n d d 3 2

APS (Auto Power Save)

APS (Auto Power Save)
Auto Power Save (APS) is a function that automatically turns the
system off if it is not used at all for 30 minutes.
1
Select "APS".
[SETUP]
[MULTI CONTROL ∞/5]
[SETUP]
2
Set the APS.
Use [MULTI CONTROL ∞/5] to select "APS ON" or "APS
OFF".
[SETUP]
3
Press [SETUP] to exit the setup mode.
• Auto Power Save (APS) will function when the volume
is set to the minimum position, the sound is muted, or
the input selector is set to one of HDMI 1 to 4 but the
HDMI indicator is not lit.
1 0 . 8 . 3 1 1 : 0 8 : 0 4 A M