Tax Table Rate; To Program A Single Tax Table Rate; To Program A Second Tax Table Rate - Royal ALPHA9155SC Manual

TAX TABLE RATE

Refer to Appendix 1 to locate the tax table codes listed for your particular state. If your state's tax rate is not
listed in Appendix 1, refer to Appendix 2 for instructions on calculating your own state's tax table codes.
Remember: Tax 1, Tax 2 and Tax 3 can be programmed with a Tax Table Rate.
Important: Step 1, on Page 25 must be completed before programming the Tax Table Rate.

TO PROGRAM A SINGLE TAX TABLE RATE

"PRG" + (ENTER TAX #) + [TAX 1] + (STATE TAX TABLE CODE) + [TAX 2] + [#/ST/NS]
Example: The tax code for Arizona's tax rate of 4% is: 138-100-4-13-19-23-27-27-29-25-25-25-25.
To program this under Tax 1, which you must have previously defined as a Tax Table Rate per the
instructions in Step 1:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. ENTER (12), then PRESS [TAX 1] key.
4. ENTER (138), then PRESS the [TAX 2] key.
5. ENTER (100), then PRESS the [TAX 2] key.
6. Continue typing the State Tax Table Codes and PRESS the [TAX 2] key after each code until finished.
7. When finished, PRESS the [#/ST/NS] key to finalize.
NOTE: If a mistake occurs during programming the State Tax Table Codes, PRESS the [CLEAR] key and begin
again with Step 3.

TO PROGRAM A SECOND TAX TABLE RATE

"PRG" + (ENTER TAX #) + [TAX 1] + (STATE TAX TABLE CODE) + [TAX 2] + [#/ST/NS]
Example: The tax code for Arizona's tax rate of 5% is: 90-100-5-11-17-20-21-21-20-20-20-20-20.
To program this under Tax 2, follow the instructions in Step 1 to designate Tax 2 as a Table Tax and
then:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. ENTER (22), then PRESS [TAX 1] key.
4. ENTER (90), then PRESS the [TAX 2] key.
5. ENTER (100), then PRESS the [TAX 2] key.
6. Continue typing the State Tax Table Codes mentioned and PRESS the [TAX 2] key after each code until
finished.
7. When finished, PRESS the [#/ST/NS] key to finalize.
NOTE: If a mistake occurs during programming the State Tax Table Codes, PRESS the [CLEAR] key and begin
again with Step 3.
1: Tax 1 + (2)
2: Tax 2 + (2)
3: Tax 3 + (2)
1: Tax 1 + (2)
2: Tax 2 + (2)
3: Tax 3 + (2)
(Continued)
Repeat for each code
Repeat for each code
TAX RATE
25