Roland FP-7F Implementation Manual page 23

● 0103: Humanizer
Adds a vowel character to the sound, making it similar to a human voice.
No Parameter Value
1 Drive Sw 0-1
2 Drive #2 0-127
3 Vowel1 0-4
4 Vowel2 0-4
5 Rate Mode 0-1
6 Rate 1-127
7 Rate #1 0-21
8 Depth 0-127
9 Input Sync Sw 0-1
10 Input Sync Threshold 0-127
11 Manual 0-100
12 Low Gain 0-30
13 High Gain 0-30
14 Pan 0-127
15 Level 0-127
● 012b: Ring Modulator
This is an effect that applies amplitude modulation (AM) to the input signal,
producing bell-like sounds. You can also change the modulation frequency in
response to changes in the volume of the sound sent into the effect.
No Parameter Value
1 Frequency #1 0-127
2 Sens 0-127
3 Polarity 0-1
4 Low Gain 0-30
5 High Gain 0-30
6 Balance #2 0-100
7 Level 0-127
● 0125: Tremolo
Cyclically modulates the volume to add tremolo effect to the sound.
No Parameter Value
1 Mod Wave 0-4
2 Rate Mode 0-1
3 Rate #1 1-127
4 Rate 0-21
5 Depth #2 0-127
6 Low Gain 0-30
7 High Gain 0-30
8 Level 0-127
Description
Off, On Turns Drive on/off.
Degree of distortion Also changes
0-127
the volume.
a, e, i, o, u Selects the vowel.
a, e, i, o, u Selects the vowel.
When this is set to "note," the
Hz, note effect is synchronized with the
tempo.
Frequency at which the two vowels
0.05-10.00 Hz
switch (Hz)
Frequency at which the two vowels
note
switch (note)
0-127 Effect depth
Determines whether the LFO for
Off, On switching the vowels is reset by
the input signal (ON) or not (OFF).
Volume level at which reset is
0-127
applied
Point at which Vowel 1/2 switch
49 or less: Vowel 1 will have a
longer duration.
0-100 50: Vowel 1 and 2 will be of equal
duration.
51 or more: Vowel 2 will have a
longer duration.
-15 - +15 dB Gain of the low frequency range
-15 - +15 dB Gain of the high frequency range
L64 - 63R Stereo location of the output
0-127 Output level
Description
Adjusts the frequency at which
0-127
modulation is applied.
Adjusts the amount of frequency
0-127
modulation applied.
Determines whether the frequency
modulation moves towards higher
Up, Down
frequencies (Up) or lower
frequencies (Down).
-15 - +15 dB Gain of the low frequency range
-15 - +15 dB Gain of the high frequency range
D100:0W - Volume balance between the direct
D0:100W sound (D) and the effect sound (W)
0-127 Output level
Description
Modulation Wave
Tri: Triangle wave
Tri, Sqr, Sin,
Sqr: Square wave
Saw1, Saw2
Sin: Sine wave
Saw1/2: Sawtooth wave
When this is set to "note," the
Hz, note effect is synchronized with the
tempo.
0.05 - 10.00 Hz Frequency of the change (Hz)
note Frequency of the change (note)
0-127 Depth to which the effect is applied
-15 - +15 dB Gain of the low range
-15 - +15 dB Gain of the high range
0-127 Output Level
● 0126: Auto Pan
Cyclically modulates the stereo location of the sound.
No Parameter
1 Mod Wave
2 Rate Mode
3 Rate #1
4 Rate
5 Depth #2
6 Low Gain
7 High Gain
8 Level
● 012c: Slicer
By applying successive cuts to the sound, this effect turns a conventional
sound into a sound that appears to be played as a backing phrase. This is
especially effective when applied to sustain-type sounds.
No Parameter
1 Rate Mode
2 Rate
3 Rate #1
4 Attack
5 Input Sync Sw
6 Input Sync Threshold
7 Mode
8 Shuffle #2
9 Level
23
Value Description
Modulation Wave
Tri: Triangle wave
Tri, Sqr, Sin,
0-4 Sqr: Square wave
Saw1, Saw2
Sin: Sine wave
Saw1/2: Sawtooth wave
When this is set to "note," the
0-1 Hz, note effect is synchronized with the
tempo.
1-127 0.05 - 10.00 Hz Frequency of the change (Hz)
0-21 note Frequency of the change (note)
0-127 0-127 Depth to which the effect is applied
0-30 -15 - +15 dB Gain of the low range
0-30 -15 - +15 dB Gain of the high range
0-127 0-127 Output Level
Value Description
When this is set to "note," the
0-1 Hz, note
effect is synchronized with the
tempo.
Rate at which the 16-step sequence
1-127 0.05-10.00 Hz
will cycle (Hz)
Rate at which the 16-step sequence
12-21 note
will cycle (note)
Speed at which the level changes
0-127 0-127
between steps
Specifies whether an input note will
cause the sequence to resume
0-1 Off, On
from the first step of the sequence
(ON) or not (OFF)
Volume at which an input note will
0-127 0-127
be detected
Sets the manner in which the
volume changes as one step
progresses to the next.
Legato: The change in volume from
one step's level to the next
remains unaltered. If the level of a
following step is the same as the
0-1 Legato, Slash one preceding it, there is no
change in volume.
Slash: The level is momentarily set
to 0 before progressing to the
level of the next step. This change
in volume occurs even if the level
of the following step is the same as
the preceding step.
Timing of volume changes for
even- numbered steps (step 2,
0-127 0-127 step 4, step 6...). The higher the
value, the later the beat
progresses.
0-127 0-127 Output level